Electronic throttle pedal

Engine throttle control system

EPS3000 Electronic throttle pedal

It sends electronic signal to ECU from set point of 0 to 10 V,
and it conducts engine feedback control by command from DCU3000 controller or upper system.
It realizes the stable control by PID control,
and it reproduce exactly the behavior of throttle pedal by high speed data acquisition.
I/O commands are available from some hardware devices.

System and application sample

Our dyno controller can control and measure by programmed operation from upper system.
And it supports expansion to existing system.

Standard test bed system (reference)

We can offer the most suitable test bed engineering to customers.
Please contact us for further details about automation of test bed, additional automation system, data acquisition sensors, test bed layout and shaft couplings.
We can offer the suitable proposal for your budget and request.

EPS3000 specification

Model	EPS3000
Data acquisition	Measurements and analog outputs at 2 kHz (16 bits / ± 10 V)
I/O	1 x Differential input 16 bits ± 10 V for 0-10 V setpoint 2 x Analog output ± 10 V for ECU inputs 2 x Digital output for the ECU control (static relay)
Interface	PC: configuration via RS232 PC: Profibus DP (digital command as option) Manual control via the “pocket” (option) Digital / Analog command: 1 x D-sub 15-pin connector Actuator control interface: 1 x D-sub 15-pin connector ECU control interface: 1 x D-sub 9-pin connector
Size (W x H x D)	240 x 180 x 70 mm
Mass (kg)	approx. 1.5kg

*Specification is subject to change due to product modification.

Catalog download

Relation Products

MORPHEE